Filter
Top Products
Chapter 3 — Configure the Computer
44 Thor CV31 Vehicle-Mount Computer User Manual
Configure 802.1x Security with Funk Security
Before you set 802.1x-WEP security with Funk security, you need to
enable the radio on your computer and set the date. To use TLS protocol,
you also need to load a user and root certificate. Intermec recommends
that you use WPA2-802.1x instead of 802.1x-WEP if possible.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Funk Security.
3 Select a Funk security profile to configure.
4 Enter the SSID.
5 For Association, select Open.
6 For Encryption, select WEP.
7 For 8021x, select TTLS, PEAP, or TLS.
8 If you selected TTLS or PEAP:
a For Prompt for Credentials, select Enter credentials now.
b Enter a User Name and a User Password.
9 If you selected TLS, enter a User Name and Subject Name.
10 For Validate Server Certificate, select Yes.
11 Tap OK.
Configure LEAP Security with Funk Security
Before you set LEAP security, you need to enable the radio and set the
date on your computer.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Funk Security.
3 Select a Funk security profile to configure.
4 Enter the SSID.
5 For Association, select Open, WPA, WPA2, or Network EAP.
The default encryption is TKIP for WPA, AES for WPA2, and WEP for
Open or Network EAP.
6 For Prompt for Credentials, select Enter credentials now.
7 Type a User Name and User Password.
8 Save your settings.