User Manual - Configuration Guide (Volume 3)
Versatile Routing Platform
Chapter 1
DDR Configuration
1-9
Table DC-1-13 Set the idle time of busy interface
Operation Command
Set the idle time of busy interface dialer fast-idle seconds
3) Set link disconnection time
When a link is disconnected due to failure or onhook, a new connection can be
established only after the set time.
Please use the following command in the configuration mode of the dial interface.
Table DC-1-14 Set link disconnection time
Operation Command
Set link disconnection time dialer enable-timeout seconds
4) Set the maximum waiting time interval from call originating to call connection
establishment.
Please use the following command in the configuration mode of the dial interface.
Table DC-1-15 Set wait-for-carrier time for port data
Operation Command
Set the maximum waiting time interval from call originating to
call connection establishment.
dialer wait-for-carrier-time seconds
5) Set access control of the dial interface
Message filtering function can be set for the dial interface. Messages passing the dial
interface can be classified into two categories through access control:
z Interesting—messages undergoing access control. When the dial interface
receives an interesting message, if the corresponding link has been established,
then DDR will send the message through this link and clear idle-time timer. If the
corresponding link has not been established, then a call will be sent.
z Uninteresting—messages not under access control. When the dial interface
receives an uninteresting message, if the corresponding link has been established,
DDR will send the message through this link and do not clear idle-time timer. If the
corresponding link has not been established, no call will be sent and this message
will be discarded.
If no dialer-group has been configured in the interface configuration, or no dialer-list
corresponding to dialer-group has been configured in the global configuration, the dial
interface cannot send the message.