Filter
Top Products
User Manual - Configuration Guide (Volume 3)
Versatile Routing Platform
Chapter 3
E1 Voice Configuration
3-12
Please use
cas-custom
command in E1 controller interface configuration mode and
perform other configurations in R2 signaling configuration mode.
Table VC-3-9 Operation & Maintenance Commands for MFC Channels and TSs
Operation Command
Enter R2 signaling configuration mode cas-custom ds0-group-number
Perform maintenance and operation to the MFC channel of the
specified TS
mfc { block | open | query } timeslots timeslots-
list
Perform maintenance and operation to the trunk circuit of the
specified TS
ts { block | open | query | reset } timeslots
timeslots-list
II. show Command Related to E1 Voice
Please use the following
show
commands to monitor in privileged mode.
Table VC-3-10 The show Commands of E1 Voice
Operation Command
Show the attribute of E1 controller port show controller e1 port-number
Show the configuration of voice port show voice-port port-number : { ds0-group-number | 15 }
Show the interface ISDN status show isdn status [ interface interface-name ]
Show the call statistics related to R2 signaling in RCV
module
show rcv statistic r2
Show the call statistics of R2 signaling show r2 call-statistics
Show the relevant information of VoIP show voip { downqueue e1vi-bno | phy-statistic e1vi-
bno | upqueue e1vi-bno | version vpu-bno }
1) Show the attribute of E1 controller port
Quidway# show controller e1 0
E1 1-0 is up.
Applique type is Channelized E1 - 120 OHM balanced
Framing is NO-CRC4, Line Code is HDB3, Source Clock is Internal.
The above packets indicate that: E1 port is activated; the impedance of the trunk is 120;
the framing mode is no-crc4; the line code is HDB3; the clock is internal clock.
2) Show the configuration of voice port
Quidway# show voice-port 0:0
The voice port was ds0
connection type is PLAR, connection number:2001
The voice port's descrition:e1-port
echo cancel enable
echo cancel coverage 16
comfort noise enable
The above packets indicate that: the E1 voice port 0:0 is in DS0 group mode; PLAR
connection is adopted and the connection number is 2001; the voice port description is
e1-port; the echo cancellation function is enabled and the time coverage of echo
cancellation sampling is 16ms; comfort noise function is enabled.