Filter
Top Products
User Manual - Configuration Guide (Volume 3)
Versatile Routing Platform
Chapter 1
VoIP Configuration
1-11
The default value of the configuration command
timing interdigit
(time interval
between the DTMF signals) is 120 ms.
The default value of the configuration command
timing wink-duration
(wink time
delay interval) is 500 ms.
The default value of the configuration command
timing wink-wait
(wink-wait time
interval) 500 ms.
The default value of the configuration command
type
(E&M trunk type) is 5.
1.2.6 Configuring Global Number Match Policy
To better adapt to the diversity of the subscriber dial plan, the number match policy
includes match as per the longest number or the shortest number. When using the
longest number match, if the input number length is less than the number length
configured by the command
destination-pattern
, please wait until timeout, and then
select the shortest number policy. When using the shortest number match, if the input
number length is greater than that configured by the command
destination-pattern
,
then the redundant numbers will be neglected.
Please make the following configurations in the global mode:
Table VC-1-7 Configuring the global number match policy
Operations Commands
Configure the number match policy of the whole office voip match-policy { longest | shortest }
By default, please use the shortest number match policy.
1.2.7 Configuring the Recovery Method of Voice Board
When the voice board becomes abnormal for some reason, two methods can be
adopted to recover the board, i.e., the manual recovery and automatic recovery. After
enabling the WATCHDOG, it will monitor the board status every five seconds and will
automatically recover the board if any abnormality is detected. In this case, manual
interference is not necessary. If WATCHDOG is disabled, the board cannot be
recovered automatically if any abnormality occurs and manual recovery is needed.
Please make the following configuration in global configuraiton mode.