Filter
Top Products
User Manual - Configuration Guide (Volume 3)
Versatile Routing Platform
Chapter 1
DDR Configuration
1-37
Quidway(config-if-Dialer0)# dialer-group 1
Quidway(config-if-Dialer0)# dialer pool 1
Quidway(config-if-Dialer0)# ppp pap sent-username userc password 0 passc
Quidway(config-if-Dialer0)# dialer string 8810148
Quidway(config-if-Dialer0)# interface bri 0
Quidway(config-if-Bri0)# no dialer in-band
Quidway(config-if-Bri0)# dialer pool-member 1
Quidway(config-if-Bri0)# encapsulation ppp
Quidway(config-if-Bri0)# ppp authentication pap
1.6.6 DDR Bearing IPX
DDR can bear both IP network layer protocol and IPX network layer protocol. Make the
following three modifications to the above-mentioned various solutions, and it is
possible to connect DDR bearing IPX.
z
Replace the statements configuring IP network layer addresses of various
interfaces with the statements configuring IPX addresses;
z Replace the IP address in dialer map configuration command with IPX address;
z Change ip in dialer-list configuration command into ipx.
The following is the implementation solution of DDR bearing IPX and oriented to
point-to-point connection. Its hardware configurations and dial string configurations are
the same as the configurations in the example “Point-to-Point DDR”.
I. Networking diagram
Router A
PSTN
Modem
Router B
Modem
8810052
8810048
Router A
ISDN
Router B
8810152
8810148
Connection using ISDN BRI PRI
through ISDN
Connection via serial port
through PSTN
Figure DC-1-9 Networking diagram of the configuration example of DDR bearing IPX
II. Configuration procedure
Solution 1: use Legacy DDR configuration mode to realize the following at the serial
port:
1) Configure router A: