Filter
Top Products
ThurayaIP Satellite Modem User Guide 9
STATUS/MENU DISPLAY
The upper level of the LCD displays status messages and menu items.
Status messages are summarized in the table below.
Display Description
Powering Off Displayed while ThurayaIP is powering down
Fault {code} A hardware fault exists, preventing operation (see
troubleshooting section for code explanations)
Too Hot A temporary thermal shutdown is about to occur
Battery Hot A temporary thermal shutdown is about to occur
due to battery heating
No SIM No SIM is detected in ThurayaIP
Locked A security code is needed (entered via wMMI)
PIN A SIM pin code is needed (entered via wMMI)
Pointing In pointing mode
GPS old GPS is older than the system time period allows
Disconnected The terminal has no IP connection to the network,
preventing data transfer
Acquiring The terminal is attempting to connect to the network
Tx{rate}/Rx{rate} Transmit and Receive streaming rates in kilobits per
second
Standard Best efforts quality of service in both directions
NAVIGATION OF THE IMMI
You navigate among the options available in the iMMI by utilizing the
Menu and Modify buttons. With the unit in its “normal” state displaying
status indicators, you press the Menu button to view and modify Quality
of Service (QoS) settings and LCD display parameters. Pressing the
Modify button within a Menu option allows you to change the current
setting.
The status display is the default display; after 30 seconds of inactivity, the
display always reverts to the status display. Pressing the Menu button
takes you through a circular list of menu items and then back to the
status display. The two major menu options are the following:
Change Rate
: Modify the QoS settings for Transmit and Receive.
LCD Contrast
: Modify the contrast on your LCD.