Filter
Top Products
4-14 701344-003
Operating Procedures
Partitioning
The Partitioning function is a controlled function. To use the Partitioning function, your
display station must be attached to a controller that supports partitioning. The display
receives partitioning commands from the host only while in Native mode.
To scroll vertically through data in the viewport during partitioning, the Back and Fwd
(Forward) keys are used in the following manner:
To scroll forward vertically (down through the data in the presentation space), press and
hold the Alt and Fwd keys. This moves the data up the viewport.
To scroll backward vertically (up to the beginning of the data in the presentation space),
press and hold the Alt and Back keys. This action pushes the data down the viewport.
Extended Select Function
To perform the Entry Assist and Response Time Monitor functions, press the Extended
Select (ExSel) key while the display station is in Native mode. The display station must
be attached to a properly configured Memorex Telex 1274 Control Unit at firmware
release 11.0 or higher, a MTX/MTC 1174 Network Controller, or any other properly
configured controller that supports Extended Select.
Extended Select Keyboard Overlays
Figure 4-5. Extended Select Overlay
(104-Key and 122-Key Keyboards)
Note: On the 122-key keyboard, to enter APL mode, press the ExSel key, then press
the F8 key.
Doc
On/Off
Wrap
Chg
Fmt
Exsel
RTM