Filter
Top Products
Table 18. Diagnostic error messages (continued)
Error Code Meaning FRU/action
014-XXX-000 Failed Parallel Port test System board
015-XXX-001 Failed USB test System board
015-XXX-015 Failed USB external loopback
test
1. Make sure parallel port is not disabled
2. Re-run USB external loopback test
3. System board
015-XXX-198 USB device connected
during the USB test
1. Remove USB devices from USB1 and USB2
2. Re-run USB external loopback test
3. System board
020-XXX-000 Failed PCI Interface test System board
020-XXX-001 Failed Hot-Swap Slot 1 PCI
Latch test.
1. PCI hot-swap latch assembly
2. System board
020-XXX-002 Failed hot-swap slot 2 PCI
latch test
1. PCI hot-swap latch assembly
2. System board
020-XXX-003 Failed hot-swap slot 3 PCI
latch test
1. PCI hot-swap latch assembly
2. System board
020-XXX-004 Failed hot-swap slot 4 PCI
latch test
1. PCI hot-swap latch assembly
2. System board
030-XXX-000 Failed internal SCSI interface
test
System board
035-XXX-099 No adapters were found If the adapter is installed, recheck the connection.
035-XXX-S99 Failed RAID test on PCI slot
S
Note: Check the System Error Log before replacing a part.
1. Adapter
2. SCSI backplane
3. Cable
035-XXX-SNN NN = SCSI ID of failing hard
disk
Note: Check the System Error Log before replacing a
part.Hard disk drive with SCSI ID NN on RAID adapter in
PCI slot S.
035-253-S99 RAID adapter initialization
failure; ServeRAID Adapter in
slot S is not configured
properly
1. Obtain the basic and extended configuration status
and refer to the ServeRAID Hardware Maintenance
Manual for more information
2. Adapter
3. SCSI backplane
4. Cable
075-XXX-000 Failed power supply test Power supply
089-XXX-001 Failed microprocessor test
1. VRM 1 for microprocessor 1
2. Microprocessor 1
089-XXX-002 Failed test for optional
microprocessor
1. VRM 2
2. Optional microprocessor 2
166-250-000 System Management failed:
(I2C cable is disconnected.
Reconnect I2C cable
between Remote Supervisor
Adapter and system board.)
1. Reseat the I2C cables between Remote Supervisor
Adapter (in PCI slot 1/J44) and system board (J45)
2. I2C cables
Appendix C. Engine POST messages 101