Filter
Top Products
Chapter 5. Installing options 43
12. Connect any needed cables to the adapter.
Attention: Route cables so that they do not block the flow of air from the fans.
The following illustration shows how to reroute the SCSI cable. If you install a
ServeRAID adapter and intend to use it with hot-swap hard disk drives, remove
the cable from the internal SCSI connector (J41) on the system board and connect
it to the ServeRAID adapter.
Note: You can also install a ServeRAID adapter in non-hot-swap models;
however, non-hot-swap models do not support hot-swap hard disk
drives.
13. If you have other options to install or remove, do so now; otherwise, replace the
support bracket assembly; then, go to “Installing the side cover” on page 60.
Note: If your server is a hot-swap model, reinstall the VRM in connector J42
after you reinstall the support bracket assembly. (See “System-board
option connectors” on page 28 for connector location.)
ServeRAID
adapter
SCSI connector
(J41)
SCSI cable