Filter
Top Products
60 IBM® xSeries 220 User’s Reference
Installing the side cover
The following information describes the cover installation procedure.
Note: The illustrations in this document might differ slightly from your hardware.
Note: If you removed the support bracket assembly after you removed the cover,
reinstall it before you install the cover.
To install the server side cover:
1. Clear any cables that might impede the replacement of the cover.
2. Align the bottom tabs of the side cover with the matching slots in the server
chassis; then, insert the tabs into the slots.
3. Close the cover-release latch to pull the cover forward and lock the cover in place.
4. Make sure that the stabilizing feet are rotated outward so that they properly
support the server.
5. Reconnect the external cables and cords to the server; then, plug the power cords
into electrical outlets.
Key lock
Cover-release
latch