Filter
Top Products
Chapter 5. Installing options 59
d. Disconnect the fan-sink power cable from the appropriate connector on the
system board:
• If you are removing the microprocessor from connector U11, disconnect
the fan-sink power cable from connector J2.
• If you are removing the microprocessor from connector U12, disconnect
the fan-sink power cable from connector J3.
7. Lift up the release lever and remove the microprocessor from the connector. Store
the microprocessor in a static-protective bag for possible future use.
8. If you are installing a new microprocessor, go to “Installing a microprocessor” on
page 54.
9. If you are not replacing the microprocessor:
a. Reinstall the terminator card in the empty microprocessor connector.
b. Press the release lever down to lock the terminator card into place.
c. Remove the VRM from the appropriate VRM connector:
• If you removed the microprocessor from connector U11, press down on
the latches on either side of connector J12, and remove the VRM from
connector J12.
• If you removed the microprocessor from connector U12, press down on
the latches on either side of connector J42, and remove the VRM from
connector J42.
10. If you have other options to install or remove, do so now; otherwise, replace the
support bracket assembly; then, go to “Installing the side cover” on page 60.