Filter
Top Products
Removing the LED bracket assembly
Note: The LED bracket assembly is hot-pluggable.
Note: Refer to “Handling static-sensitive devices” on page 4-1.
1. Remove the fan assembly housing the LED bracket assembly.
v Refer to “Removing a fan assembly” on page 4-2.
2. Remove the LED bracket mounting screw from the side of the fan assembly.
3. Remove the LED bracket assembly.
Note: If you are replacing a failed fan, save the LED bracket assembly for use with the new fan.
Replacing the LED bracket assembly
1. Mount the LED bracket assembly in the fan assembly.
2. Secure the LED bracket assembly to the fan assembly side wall with the mounting screw.
3. Replace the fan assembly.
v Refer to “Replacing a fan assembly” on page 4-2.
4. Return to the procedure that directed you here.
Figure 4-3. Removing SP Switch2 power and environmental LED assembly
SP Switch2 service procedures
4-4
RS/6000 SP: SP Switch2 Service Guide