Filter
Top Products
Removing the switch supervisor card
Note: The switch supervisor card is hot-pluggable.
Note: Refer to “Handling static-sensitive devices” on page 4-1.
1. Remove the switch supervisor cable from the supervisor card located in slot J2.
2. Loosen the captive screw holding the card retention bracket to the switch chassis.
3. Swing the bracket out and remove it from the switch chassis.
4. Remove the supervisor card from switch by pulling outward on the card’s hot-plug actuator.
Figure 4-4. Removing and replacing SP Switch2 supervisor and interposer cards
SP Switch2 service procedures
Chapter 4. FRU removals and replacements 4-5