Filter
Top Products
Rear View of the Fibre Channel Drive
1 Power connector
2 Loop identifier (LID)/status connector
3 Fibre Channel connector
4 RS-422 connector (J2)
Step 1. Unpack the Drive
Unpack the Ultrium Tape Drive and store the packaging. You may need the
packaging if you return the unit for service.
Step 2. Power-off the Enclosure (Optional)
It is recommended (but not required) that you power-off the enclosure when you
install or remove the tape drive.
Step 3. Install the Cooling Fan Assembly (Optional)
The Ultrium Tape Drive’s circuits require cooling. The drive is designed to move air
across the circuits, with air entry at the lower front of the drive (the tape path and
drive head are protected from airflow and associated debris).
If the cooling fan is not attached and the temperature inside your enclosure does
not meet requirements, install the IBM cooling fan assembly (see the temperature
requirements in Table 2 on page 7). The procedure for installing the fan varies,
depending on whether your drive uses a SCSI or Fibre Channel interface. The
sections that follow describe each procedure.
Figure 3. Rear View of the Ultrium Internal Tape Drive - Fibre Channel Drive
Chapter 3. Installing 11
|
||
||
||
||
|
|
|
|