Filter
Top Products
Removing the Fibre Channel Tape Drive
To remove the Ultrium Internal Tape Drive Model T200F from an enclosure, perform
the following steps:
1. Ensure that the tape drive does not contain a tape cartridge.
2. Deconfigure the drive from the server (for instructions, see your server’s
documentation).
3. Turn off the power to the enclosure.
4. Disconnect the internal power cable from the power connector (see 1 in
Figure 22).
5. Disconnect the internal RS-422 cable from the J2 connector 4.
6. Disconnect the internal fiber cable from the Fibre Channel connector 3.
7. Disconnect the fiber address cable from the LID/status connector 2.
8. Remove the mounting screws from the side brackets of the chassis (see 2 in
Figure 7 on page 20).
9. Remove the tape drive from the enclosure.
a67e0045
1
2
3
4
Figure 22. Rear View of the Ultrium Internal Tape Drive Model T200F (Fibre Channel Drive)
72 IBM Ultrium Internal Tape Drive
|
|
|