Filter
Top Products
2. To find the end of the tape inside the cartridge, attach the cartridge manual
rewind tool (1 in Figure 14) to the cartridge’s hub 2 by fitting the tool’s
teeth between the teeth of the hub. Turn the tool clockwise until you see the
end of the tape inside the cartridge. Then, slowly turn the rewind tool
counterclockwise to bring the tape edge toward the cartridge door 3.
3. Continue to turn the rewind tool counterclockwise until approximately 12.7 cm
(5 in.) of tape hangs from the cartridge door. If necessary, grasp the tape and
pull gently to unwind it from the cartridge.
4. Remove the rewind tool by pulling it away from the cartridge. Set the tool and
the cartridge aside.
5. On the leader pin (1 in Figure 15), locate the open side of the C-clip 2.
The C-clip is a small black part that secures the tape 3 to the pin.
6. Remove the C-clip from the leader pin by using your fingers to push the clip
away from the pin. Set the pin aside and discard the clip.
Figure 14. Winding the Tape Out of the Cartridge. Turn the cartridge manual rewind tool
clockwise to see the end of the tape, then turn it counterclockwise to bring the tape to the
cartridge door.
A67E0036
1
2
3
Figure 15. Removing the C-Clip from the Leader Pin. Use your fingers to push the C-clip
from the leader pin.
46 IBM Ultrium Internal Tape Drive