Filter
Top Products
Step 4. Set the SCSI ID (SCSI Drive Only)
Notes:
1. When setting the SCSI ID, use the 2-mm jumpers that come attached to the
Ultrium Tape Drive’s SCSI ID connector (four jumpers are shipped on the
connector; an additional jumper is unattached, but included in the ship group).
To order additional jumpers, contact your IBM marketing representative.
2. If your enclosure uses a SCSI ID switch (rather than jumpers), do not perform
the following procedure. Instead, remove the jumpers from the Ultrium Tape
Drive and connect the switch (for instructions, refer to your enclosure’s
documentation).
3. If you are installing the Ultrium Tape Drive into a tape library, make sure that the
drive’s SCSI ID is set at 15 (see settings below). The library may issue a
command to the tape drive to set the SCSI ID via the RS-422 interface.
To set the SCSI ID:
1. Locate the SCSI ID connector (see 2 in Figure 2 on page 10).
2. Before attaching the SCSI bus cable to the server, decide the number of the
SCSI ID that you want. Make sure that the ID is not being used by another
device.
3. Referring to the following figure, find the ID number that you chose, then place
jumpers on the connector pins as shown (use a pair of needle-nose pliers to
connect the jumpers to the pins that are shaded).
14 IBM Ultrium Internal Tape Drive
|
|
|
|
|