Filter
Top Products
Installing the Cooling Fan onto a SCSI Drive
To install the optional cooling fan assembly onto an Ultrium Tape Drive that uses a
SCSI interface:
1. Remove and discard the two cover screws from the rear of the Ultrium Tape
Drive (see 1 in Figure 4). Use a Phillips screwdriver to remove the screws.
2. Position the fan shroud 2 at the rear of the drive and align its top with the top
of the drive.
3. Attach the fan shroud to the rear of the drive by securing the two captured
screws 3 with a Phillips screwdriver.
4. Connect the SCSI bus cable 4 to the connector at the rear of the SCSI drive.
5. Attach one end of the Y-cable 5 to the drive’s power connector.
6. Attach the fan cover assembly 6 to the fan shroud 2 by securing four
screws 7 with a Phillips screwdriver.
7. Connect the other end of the Y-cable 8 to the fan assembly’s power connector
9.
8. Connect the Y-cable 10 to the power supply in the enclosure.
Figure 4. Installing the Cooling Fan Assembly onto a SCSI Drive
12 IBM Ultrium Internal Tape Drive
|
|
|
|
|
|
|
|
|