Filter
Top Products
1
Intel Express
100BASE-TX Switching Hub
Console Mgmt
SNMP Pwr
Mgmt Fault
MDI
MDI
Xmt FC/FD Mgm
Rcv Clsn Link
Xmt FC/FD Mgmt
Rcv Clsn Link
MDI
Xmt FC/FD Mgmt
Rcv Clsn Link
MDI
Xmt FC/FD Mgmt
Rcv Clsn Link
MDI
Xmt FC/FD Mgmt
Rcv Clsn Link
PC-3435
Xmt FC/FD Mgm
Rcv Clsn Link
Port 2
Port 7
Port 6Port 5Port 3 Port 4
Port 1
Rcv Clsn Link
Xmt FC/FD Mgm
100BASE-TX
Rubber feet for shelf or table placement.
Brackets and screws for standard
19-inch equipment rack placement.
Crossover cables to
servers/workstations
Straight-through
cables to hubs
100BASE-TX server/
workstation
100BASE-TX hub
Intel Express
100BASE-TX Switching Hub
Console Mgmt
SNMP Pwr
Mgmt Fault
MDI
MDI
Xmt FC/FD Mgm
Rcv Clsn Link
Xmt FC/FD Mgmt
Rcv Clsn Link
MDI
Xmt FC/FD Mgmt
Rcv Clsn Link
MDI
Xmt FC/FD Mgmt
Rcv Clsn Link
MDI
Xmt FC/FD Mgmt
Rcv Clsn Link
PC-3436
Xmt FC/FD Mgm
Rcv Clsn Link
Port 2
Port 7
Port 6Port 5Port 3 Port 4
Port 1
Rcv Clsn Link
Xmt FC/FD Mgm
100BASE-TX
PwrStatRPSColData %
Expansion Slot
1
1
13
2
14
3
15
4
16
5
17
6
18
7
19
8
20
9
21
10
22
11
23
12
Mstr
Stat Enbl
Stat
24
Port Status
Media Adapter
Management
²15101525³30
100 BASE-T4
Expansion Slot
Media Adapter
1
243
65871091211
Intel Express
100BASE-T4 Stackable Hub
MDI
Xmt FC/FD Mgmt
Rcv Clsn Link
Port 3
PC 3396
Lights when device is
plugged into the port.
Console Mgmt
SNMP Pwr
Mgmt Fault
Blinks every two seconds.
Lights briefly while the switch
performs self-tests.
Should always be on.
NOTES
• Connect only 100 Mbps devices to the
switch. See page 12 for information on
connecting to 10 Mbps segments.
• The default configuration for each port is
half duplex mode only.
• Always use Category 5 cabling.
Quick Start
1. Install the Express 100BASE-TX Switching Hub in a rack or on a shelf or table,
plug the cord in, and turn the power on. See page 5 (steps 1 and 2).
2. Connect the network devices to the switch. See page 5 (step 3) and pages 10–12.
3. Check the LEDs for power and links. See pages 6 and 7.
Next steps (Optional)
• Continue to the next page if you want to configure the switch to work with an SNMP-compliant
Network Management System (NMS).
• See Chapter 2 if you want to use the Console Manager to change port configurations (set a port for
full duplex), assign an IP address, or check port statistics.