Filter
Top Products
49
Configuring and Managing the Switch
CHAPTER 2
Port configuration commands
This section contains instructions for configuring and displaying port
settings with the Console Manager.
get-port-cfg
Displays the current port configuration.
SYS_console>get-port-cfg
PORT_ID LAN_TYPE LINK IF_TYPE PORTSEL FDPLX FCTRL
========================================================
1 NONE ---- PORT NOT INSTALLED ----
2 NONE ---- PORT NOT INSTALLED ----
3 ETH100X OFF TPFD TP OFF ON
4 ETH100X OFF TPFD TP OFF ON
5 ETH100X OFF TPFD TP OFF ON
6 ETH100X OFF TPFD TP OFF ON
7 ETH100X OFF TPFD TP OFF ON
The command displays the following information for each port:
• LAN type: ETH100X indicates 100BASE-TX Fast Ethernet
• Link status: ON or OFF
• Physical interface type: TPFD indicates Twisted-pair (TP)
Ethernet, Full Duplex (FD) capable
• Physical interface selected: TP for the Express Switching Hub
• Full duplex mode: ON or OFF (default)
• Flow control: ON or OFF. If you set a port to full duplex, flow
control is automatically turned off (changes take effect after a
reset). If you try to set flow control to ON while full duplex is
selected, the Console Manager ignores the change on reset.
set-port-dplex
set-port-dplex <
port_number
> {half|full}
Specifies whether the given port is in full-duplex or half-duplex
(standard Ethernet) mode. The default is half-duplex.
SYS_console> set-port-dplex 2 full
Port configured in <full_duplex> mode
Parameter change in NVRAM OK