Filter
Top Products
50
CHAPTER 2
Intel Express 100BASE-TX Switching Hub
set-port-fctrl
set-port-fctrl <
port-number
> {on|off}
Turns the flow control feature on or off for the specified port. The
default is on.
If the port is in full-duplex mode, flow control is automatically off. If
you try to set it to ON while full-duplex is enabled, the Console
Manager ignores the change after a reset. Flow control or full duplex
can be active, or neither, but not both.
SYS_console> set-port-fctrl 2 off
Port 2 - flow control <off>
Parameter change in NVRAM OK
Switching statistics commands
This section contains instructions for displaying switching statistics
using the Console Manager. The following commands provide full
physical layer information as well as interport switching statistics.
clr-cnt
Clears (resets) the Ethernet and bridging statistical counters.
get-eth-cnt
get-eth-cnt <
port-number
>
Displays the Ethernet Statistics Counters for port
port-number
. This is
almost identical to the Ethernet-like Statistics Group of the Ethernet
MIB.
SYS_console> get-eth-cnt 3
Ethernet Statistics for port 3
=================================
Transmit OK : 1427908
Underflow Errors: 153
Exces Coll Errors: 0
Exces Fctrl Errors: 0
Receive EOF : 1443206
Receive OK : 1443192
Overflow Errors: 2
CRC Errors: 9
Alignment Errors: 0
Runt Errors: 6
Lost/Fctrl Errors: 0
Too Long Errors: 0
=================================