Filter
Top Products
IXD1110 Demo Board
16 Development Kit Manual
Document Number: 250807
Revision Number: 003
Revision Date: June 27, 2003
5.2 Installing the IXF1110 Software
For proper installation of the IXF1110 software, follow these steps:
1. Verify that the CAT5-UTP cable is connected between the PC and the IXF1110 CPU daughter
card. This allows access to the GUI interface. Refer to Section 4.0, “CPU Daughter Card” on
page 13 for detailed installation instructions.
2. (Optional) The following connection is required to access the HyperTerminal interface:
— CAT5-UTP cable (connected to a CPU daughter card)
— DB-9–to–RJ-45 connector (connected to a CAT5-UTP cable)
— DB-9–to–RJ-45 connector (connected to a COM port on a PC installed with IXF1110
software)
For more information, refer to Section 4.0, “CPU Daughter Card” on page 13 for detailed
instructions.
3. Insert the CD into the PC.
4. If your system supports Autorun, follow the on-screen instructions.
5. If your system does not support Autorun, select Run... from the Start menu. The Run dialog
opens.
6. Select setup.exe from the CD in the Open: window (click Browse... to find setup.exe if not
already in the window).
7. Click OK.
8. Follow the on-screen instructions.
9. Locate the IXD1110 demo board IP address that is located on the CPU daughter card. The IP
address is required each time the GUI is opened.
10. Start the IXF1110 software GUI by double clicking the desktop icon.
Note: The IXF1110 software includes online documentation that describes how to run the GUI and
HyperTerminal interfaces. Refer to the quick-start section of the IXF1110 Demonstration Software
Help File for additional instructions on use of these interfaces.
5.3 Changing the IP Address of the CPU Daughter Card
(Optional)
The CPU daughter card comes with a default IP address, which is listed on a sticker attached to the
daughter card. The GUI uses this IP address to locate the IXD1110 demo board. The IP address
may need to be changed depending on the PC or network to which the board is attached. Use the
following procedure to permanently change the IP Address of the CPU daughter card:
1. Ensure the IXD1110 demo board has been set up correctly (see Section 2.0, “Quick Start” on
page 11).
2. Open the HyperTerminal on the PC to which the CPU daughter card serial port is attached, and
configure the relevant COM port with the following settings:
• Speed: 9600 Baud
• Databits: 8