Filter
Top Products
IXD1110 Demo Board
Development Kit Manual 9
Document Number: 250807
Revision Number: 003
Revision Date: June 27, 2003
1.3.2 Component Location and Description
Figure 1 illustrates the top view of the IXD1110 demo board.
Table 1 provides a list of the various principal components found on the IXD1110 demo board.
Figure 1. Intel
®
IXD1110 Demo Board (Top View)
GND
Intel
®
IXF1110
Intel
®
IXF1110
LEDs
FPGA
Reset
S1
JP2
Mictor Connector
Probe A
Mictor Connector
Probe C
Mictor Connector
Probe D
J
T
A
G
GBIC SFP
Connectors
Port 0
Port 1
Port 2
Port 3
Port 4
Port 5
Port 6
Port 7
Port 8
Port 9
JP1
SPI4-2
Connector
GND 1.8 V IXF 2.5 V IXF 3.3 V 2.5 V
EPROM
SMB Connectors
Table 1. Intel
®
IXD1110 Demo Board Principal Components
Component Description
IXF1110
10-port Gigabit MAC that supports IEEE 802.3 1000 Mbps applications. Refer to the
IXF1110 Datasheet for additional information.
IXF1110 LEDs
The IXF1110 uses a serial interface consisting of three signals to provide LED data to
an external driver. This interface provides the data for 30 separate direct drive LEDs
and allows three LEDs per MAC port. Refer to Section 7.0, “LEDs” on page 19.
JP1
This jumper provides access to the JTAG test signals. Refer to Section 6.2, “JTAG
Test Signals” on page 18.
JP2
This reset jumper is required for proper board operation. Refer to Section 6.1, “Reset
Jumper JP2” on page 18 for more information.
1. For evaluation of the signals provided by the Mictor connector, use the corresponding logic analyzer probe.