Filter
Top Products
IXD1110 Demo Board
Development Kit Manual 7
Document Number: 250807
Revision Number: 003
Revision Date: June 27, 2003
1.0 Introduction
This document describes all the necessary requirements, settings, and procedures for evaluating the
Intel
®
IXF1110 10-Port 1000 Mbps Ethernet Media Access Controller (MAC) using the
Intel
®
IXD1110 demo board. For immediate operation, refer to Section 2.0, “Quick Start” on
page 11. For optional configurations, see Section 6.0, “Optional Configurations” on page 18.
The IXD1110 demo board kit includes a CPU daughter card that attaches to the underside of the
board. Through the CPU daughter card, the Intel
®
IXF1010/IXF1110 10-Port 100/1000 Ethernet
MAC Demonstration Software (included on the CD) provides access to all IXF1110 registers and
RMON statistics.
Additional sections include information about LEDs, test points, board schematics, and a bill of
materials.
Note: For comprehensive information in evaluating the IXF1110 using the IXD1110 demo board, use the
IXF1110 Demonstration Software Help File and the IXF1110 Datasheet (document number
250210) in conjunction with this document.
1.1 About This Kit
The IXD1110 demo board kit includes the following:
• IXD1110 demo board with CPU daughter card
• IXF1110 Demonstration Software CD (includes a software help file)
• SPI4-2 loopback connector
• IXD1110 Demo Board Development Kit Manual
1.2 Additional Equipment Required
The following additional equipment is required for board setup:
• Packet Generator with 1000BASE-SX capabilities
• 3.3 V DC power supply with 6A current capability
• 2.5 V DC power supply with 6A current capability
• 1.8 V DC power supply with 6A current capability
• One to ten fiber cables (for data transmission)
• Two CAT5-UTP cables (for IXF1110 software)
• DB-9–to–RJ-45 converter [optional] (for IXF1110 software)
• PC (for IXF1110 software) (see Section 5.1, “PC Requirements” on page 15)
• GBIC SFP modules [up to 10] (Agilent* HFBR-5710L)