Filter
Top Products
TM700 User Guide - Upgrading Your System
4 - 9
Removing and Replacing the 3.5/5.25-inch
Bracket
This section of the chapter describes how to remove and replace the 3.5/5.25-inch
bracket containing the two 5.25-inch bays and the two 3.5-inch bays.
Removing the 3.5/5.25-inch Bracket:
1. Remove the screw securing the HDD bracket and the 3.5/5.25-inch bracket
together.
Figure 4 - 5 : HDD Bracket Screw
2. Disconnect all cables (power, data, and others, if applicable) from the installed
3.5- and 5.25-inch devices.
Caution
Be careful when working around the cables connected to the
already installed drives.
If necessary disconnect these cables, but be sure to note which
device each cable or power lead was attached to.