Filter
Top Products
TM700 User Guide - Upgrading Your System
4 - 38
Preparing an IDE Hard Disk Drive
Before installing a hard disk drive in the system, it should be set as a master or a slave
device using the drive select jumper on the back of the drive. Refer to the ‘IDE Device
Configuration’ hereafter for details about configuring IDE drives as master or slave.
Refer to the instructions printed on the device for further jumper setting information.
■
A - Jumper block
Figure 4 - 34 : Connectors on the back of a hard disk drive (example)
Preparing a S-ATA Hard Disk Drive
S-ATA hard disk drives do not need being prepared.
Preparing a Tape Drive
Before installing a tape drive in the system, it should be set as a master or a slave
device using the drive select jumper at the back of the drive. Refer to the ‘IDE Device
Configuration’ hereafter for details about configuring IDE drives as master or slave.
Refer to the instructions printed on the device for further jumper setting information.
■ Master Setting
■ Slave Setting
■ Cable Select
Figure 4 - 35 : Connectors on the Back of a Tape Drive (example)