Filter
Top Products
TM700 User Guide - Upgrading Your System
4 - 35
2. Locate an available power connector coming from the power supply.
3. Connect the appropriate power cable (B) to the power connector on the storage
device.
Figure 4 - 29 : Cabling an IDE Hard Disk Drive
■ A - IDE cable
■ B - Power cable
■ C - Red edge (Pin 1)
S-ATA Hard Disk Drive
1. Connect the S-ATA cable connector to the matching pins on the storage device.
■ Take care to prevent bending drive connector pins.
■ Align the cable connector to the matching pins on the drive. Black side
goes to hard disk drive; blue side goes to motherboard. Refer to S-ATA
Hard Disk Drive picture hereafter.
2. Locate an available power connector coming from the power supply.
3. Connect the appropriate power cable to the cable power adaptor.
4. Connect the power cable adaptor to the connector on the storage device.
Figure 4 - 30 : S-ATA Hard Disk Drive