Filter
Top Products
TM700 User Guide - Upgrading Your System
4 - 37
Preparing the Device
Note: Please note that in normal operation mode, the
‘cable select’ position is recommended for all IDE devices.
Preparing a CD-ROM or DVD-ROM Drive
Before installing a CD/DVD-ROM drive in the system, the jumper on the back of the
drive must be set as “cable select”. Refer to the ‘IDE Device Configuration’ hereafter
for details about configuring IDE drives as master or slave. Refer to the instructions
printed on the device for further jumper setting information.
■ A - Jumper block
Figure 4 - 32 : Connectors on the back of a CD/DVD-ROM or CD-RW drive (example)
■ A - Master
■ B - Slave
■ C - Cable select
Figure 4 - 33 : Jumper settings (example)