Filter
Top Products
TM700 User Guide - Upgrading Your System
4 - 18
Installing or Removing Hard Disk Drives
This section describes how to remove, replace and add Hard Disk Drives.
Removing a Hard Disk Drive
1. Remove the right side door. See “Removing the Right Side Door:” on page 4-6.
2. Remove the front panel. See “Removing the Front Panel:” on page 4-8.
3. Remove the screw (A) securing the HDD bracket and the 3.5/5.25-inch bracket
together. See “Removing the 3.5/5.25-inch Bracket:” on page 4-9.
Figure 4 - 16 : HDD Bracket Screw
4. Disconnect the DATA cable and the power cable from each hard disk drive
installed.
Caution
Be careful when working around the cables connected to the
already installed drives.
If necessary disconnect these cables, but be sure to note which
device each cable or power lead was attached to.