Filter
Top Products
TM700 User Guide - Upgrading Your System
4 - 14
Installing or Removing a 3.5-inch Floppy Disk
Drive
This section describes how to remove, replace and add 3.5-inch Floppy Disk Drives
(FDDs). Two 3.5-inch floppy disk drives can be installed in the FDD bracket. If a
floppy disk drive was installed into your system at the factory, it is located in the upper
slot of the bracket.
Removing a 3.5-inch Floppy Disk Drive
To remove the floppy disk drive from the upper 3.5-inch slot of the 3.5/5.25-inch
bracket:
1. Remove the right side door. See “Removing the Right Side Door:” on page 6.
2. Remove the front panel. See “Removing the Front Panel:” on page 8.
3. Remove the 3.5/5.25-inch bracket. See “Removing the 3.5/5.25-inch Bracket:”
on page 9.
4. Remove the three screws (A) securing the floppy disk drive to the bracket (two
on the left side and one on the right side)
Figure 4 - 12 : Removing the Screws
5. Slide the floppy disk drive out of the bracket.
Figure 4 - 13 : Sliding the Floppy Disk Drive out
6. Set the floppy disk drive aside.