Filter
Top Products
TM700 User Guide - Upgrading Your System
4 - 21
6. Remove the two screws (B) holding the HDD bracket to the front of the
chassis, slide the HDD bracket backwards, and set it aside.
Figure 4 - 19 : HDD Bracket Screws
Caution
Be careful when working around the cables connected to the
already installed drives.
If necessary disconnect these cables, but be sure to note which
device each cable or power lead was attached to.
7. Notice the screw holes located on each side of the HDD bracket (B & C) and
under the HDD bracket (A), and the corresponding screw holes located on the
hard disk drive you mean to install. Making sure the screw holes will line up,
slide the hard disk drive into one of the available slots, connectors last.
8. If in slot C, secure screws into the four side screw holes of the hard disk drive.
9. If in slot A, secure screws into the four top screw holes of the hard disk drive.
10. Slide the HDD bracket along the 3.5/5.25-inch bracket. Make sure that the four
tabs located on the open side of the HDD bracket are fully inserted into their
slots, and that the two screw holes located on the front of the chassis are lined