ZyAIR B-4000 Hot Spot Gateway
WAN, LAN and Server Setup 4-9
The following table describes the fields in this screen.
Table 4-2 SERVER
LABEL DESCRIPTION
Web Server
Web Server Port Specify the port number of the embedded web server on the ZyAIR for accessing
the web configurator. The default port number is 80. Changing the port number
helps protect the ZyAIR’s web configurator from hacker attacks.
Enter a number between 8010 and 8060 to access the web configurator behind a
NAT-enabled network.
If you enter a number between 8000 and 8060, you need to append the port
number to the WAN or LAN port IP address to access the web configurator. For
example, if you enter “8010” as the web server port number, then you must enter
“http://www.192.168.1.1:8010” where 192.168.1.1 is the WAN or LAN port IP
address.
SSL Security Secure Socket Layer (SSL) security allows you to create secure connections
between the ZyAIR and the management computer(s). Refer to the SSL (Secure
Socket Layer) Security chapter for more information.
Select this check box to activate SSL security.
Administrator Idle-
Timeout
Type how many minutes a management session can be left idle before the session
times out. The default is 5 minutes. After it times out you have to log in with your
password again. Very long idle timeouts may have security risks. A value of "0"
means a management session never times out, no matter how long it has been left
idle (not recommended).
DHCP Server
Select the DHCP mode on the LAN.
DHCP Disable Select this option to disable DHCP server on the LAN.
DHCP Relay Use this if you have a DHCP server (either a computer or another router) and you
want that DHCP server to also assign network information (IP address, DNS
information etc.) to the devices that connect to the ZyAIR. Select this option to set
the ZyAIR to forward network configuration requests to a DHCP server.
Then configure the DHCP Server IP Address field.
DHCP Server IP
Address
If you select DHCP Relay, enter the IP address of a DHCP server (on the WAN).