Filter
Top Products
Kodak 10/100 NIC Introduction and Configuration
July 1998 1-9
I
N
T
R
O
D
U
C
T
I
O
N
NIC ConÞguration Software
¥
Windows: The NIC may be conÞgured from Windows-based platforms
using NIC FastManage, NBMon or Telnet utilities. Refer to the
Windows FastManage Utility chapter.
¥ Macintosh: The NIC may be conÞgured from Macintosh-based
platforms using NIC LaserWriter utilities. Refer to the Apple Macintosh
- Laserwriter Utilities section. Telnet may also be used.
¥ Unix: Use Telnet utilities.
¥ Telnet: The NIC may be conÞgured from any platform supporting TCP/
IP via TELNET utilities after an IP address has been established.
Refer to Appendix A, Telnet.
IMPORTANT: This 10/100 NIC is configurable ONLY by using remote
configuration utilities listed above. Use of the front control
panel and corresponding test page is not pertinent to this
NIC.
Step 5: ConÞgure the print servers, if necessary
Determine whether server print queues will be used and conÞgure the
appropriate servers.
Chapter 4 describes how to conÞgure Novell servers.
Procedures for conÞguring Windows NT servers are identical to
procedures for conÞguring Windows NT workstations with the exception
of ÒsharingÓ the printer. Refer to Windows NT chapters.
Step 6: ConÞgure the printer on workstations
Determine the printer modes (PostScript and raster) that will be used.
Install the PostScript and raster printer software.
PostScript mode: PostScript printer drivers or PPDs must be installed on
each platform that prints to the printer.