Filter
Top Products
3.11.2 IP Address Validation Messages
The following table displays messages that you may see when entering
an IP address:
General Messages
Message Cause Solution
Bad status from target
device: <n>. Press
CANCEL to exit
program
Appears when the
SNMP agent on device
returns a
NO_SUCH_NAME for a
particular OID
The Þrmware on the agent
does not match with the
version of the Manager
software. Upgrade the agent
Þrmware and the
FastManage Software
Package.
Unable to open SNMP
Session
Usually appears if the IP
stack on the manager
has died
Restart Windows.
Bitmap Init Error Application is not able to
Þnd the bitmap
The FastManage installation
may be bad. Reinstall.
Unable to load
NPAPI.DLL
File NPAPI.DLL could
not be found
Put the Þle NPAPI.DLL in the
path.
Unable to load
NPSNMP.DLL
File NPSNMP.DLL could
not be found
¥ Put the Þle NPSNMP.DLL in
the path.
¥ Set NetBeui as a default
using the Network Control
Panel.
WINSNMP Error (%ld)
sending%s packet
Appears when the
manager is not able to
send a WINSNMP
packet. Sometimes
occurs due to an SNMP
agent in the device that
crashed.
Use the PING application to
Þnd out if the agent device is
reachable. If yes, restart
Windows. If not, power cycle
the device and try again.
IP Address Validation Messages
Message Solution
More than 3 dots exist in the address or No
characters present between dots or Invalid
character in IP Address or The address
contains one Þeld with value more than 255.
Not all Þelds are deÞned.
A valid IP address is of the form
a.b.c.d, where a.b.c.d can vary
from 0 to 255. For example,
193.25.86.214