Filter
Top Products
A-61140 January 2000 8-37
8. Check for any accumulation of ink on the jets or face of the ink
cartridge. Wipe any ink from the jets and face with a clean,
dampened lint-free cloth.
Jets
Ink cartridge
face
9. Prime the ink cartridge by carefully inserting the end of a paper clip
into the hole at the end of the ink cartridge and gently push in on the
bladder. Allow a small amount of ink to escape through the jets.
Ink cartridge
Bladder (inside ink
cartridge
10. Remove the paper clip and observe the ink flow back into the bladder
through the jets.
11. Use a dry, lint-free cloth to wipe the face and jets of the ink cartridge.
12. Slide the ink cartridge back into the carriage.
13. Lower the holding bar back down to its original position.
14. If necessary, wipe the carriage clean with a dry, lint-free cloth.
15. Wipe the rear Document Printer mounting plate clean of any ink
deposits.
16. Press the carriage spring clips together to place the rear Document
Printer carriage into the rear Document Printer mounting plate.
17. Close the upper access door.
18. Enter function code F45 to perform a print test.