Filter
Top Products
12-10 Shortcuts
Shortcuts
Loading Paper (p. 14-2)
Main Body User-Adjustable Trays: Tray 1 (500), Tray 2 (500), and Tray 3 (1,000)
1 Withdraw the main body tray, then place paper into the tray with the curl turning up.
Load size 11"x17", 8.5"x14", 8.5"x11", 8.5"x11"R or 5.5"x8.5" (portrait).
Do not stack paper above the level of the red line.
2 Move the green levers located at the front and left side until they meet the edge of
the stack of paper.
3 When paper is seated properly, push the tray back fully into the copier.
LCT (Large Capacity Tray) Service-Adjustable: Tray 4 (4,000)
1 Open the LCT upper door (lift lid).
2 Press the Paper load button located at the front of the LCT to lower the bottom place
of the LCT.
3 Load the fixed size paper (8.5"x11" or A4) into the LCT with the paper curl turning
down (see note).
4 Repeat Steps 2 and 3 until the bottom plate cannot go down any more.
Do not stack paper above the paper hook level.
5 When the stack of paper is seated properly in the tray, close the LCT upper door
(lid).
NOTE: When loading Tab sheets, be sure the tab extensions are positioned at the rear side of the tray (not at
the front where the Paper load button is located), and jutting to the right, away from the hinged side of
the LCT cover.
Adding Toner (p. 14-7)
CAUTION
Do not incinerate toner and toner containers. Dangerous sparks may cause
burn.
1 Open the machine front door and pull out the toner unit 90° to the right.
2 Move the toner cartridge lock lever toward the front until it stops, then remove the
empty toner cartridge.
3 Shake the new toner cartridge several times to loosen toner, then remove the
cartridge protective cap.
4 Set the new toner cartridge into the toner unit, aligning the hollow part of the
cartridge with the arrow on the toner unit.
5 Move the toner cartridge lock lever BACK until it stops, then return the toner unit to
its original position.
6 Close the machine front door.