Filter
Top Products
Key Operator Mode 13-41
Key Operator Mode
Memory Switch Setting [13] (continued)
No. 36: E.C.M. password input timing Auto reset timer/ Complete job
No. 37: Key click sound (No paper/JAM) OFF/ 3 seconds/ 5 seconds/ 10 seconds
No. 38: Reserve copy function
Reserve copy by folder select/ Reserve copy by
original set
No. 39: Scan stop by a pull out tray ON/ OFF
No. 40: Change page no. pos. (booklet) OFF/ ON (Outside page numbering)
No. 41: Trimmer (STD/Non STD size) STD size/ None STD size
(no function)
Key Operator Mode Screen 1 Key Operator Mode Screen 2
1 Press [HELP] to display the Help Screen, then touch Key Operator Mode.
Enter a 4-digit key operator password, then touch OK to display the Key Operator
Mode Screen. (See note.)
2 To display menus [11] to [18] of the Key Operator Mode Screen, touch Lower
arrow key.
3 Touch [13] Memory switch setting to display the Memory Switch Setting Screen.
4 Use the procedure below to select the desired item and change the setting.
(1) To select the desired item, touch the arrow keys (▲) and (▼) at the right of the
Memory Switch Setting Screen.
(2) To scroll the screen, touch the arrow keys and at the lower left.
(3) Touch Change Setting Contents to change the setting of the highlighted item.
(4) Repeat above steps (1) to (3) to make several changes in succession.
5 Touch PREVIOUS SCREEN to restore the Key Operator Mode Screen. If other key
operator settings are required, select the desired menu item, from [1] to [18].
6 If no further changes are required, touch PREVIOUS SCREEN to restore the Basic
Screen to perform copying operations.
Memory Switch Setting Screen
NOTE: If an invalid Key operator password is entered, continue by entering the valid 4-digit password.