Filter
Top Products
6-9
FS-1010
Indicator
Remote Operation Panel
display Description
Current print processing cannot
continue due to complex data.
The data transferred to the printer was
too complex to print on a page. Press
the Go key to print data as far as it was
stored. You can abandon printing by the
Cancel key.
Note: To release the page protect mode,
send the following command to the
printer from the Remote Operation
Panel utility after this error occurs:
!R! FRPO R5, 1; EXIT;
Check the error code displayed in ##
and refer to the appropriate description
below.
01: Abnormal format. Try turning the
power off and on again.
02: RAM disk mode is Off. Turn RAM
disk mode On.
04: No disk space. Clean up files.
05: Specified file is not on disk.
06: No memory for use by disk system.
Expand printer memory.
(Continued on next page)
The printer has halted because you
attempted to insert/remove a memory
card into/from the printer slot while the
printer power is on.
Turn the power switch off and then on
to restart the printer.
Note: Make sure to turn the printer
power off before inserting/removing a
memory card.
(No indication patterns available)
This message appears when the printer
is in the ready state and the memory
card is not formatted, and therefore
cannot be read or written.
Format the memory card.
Print overrun
Press GO
MemoryCard err##
Press GO
MemoryCard err20
Format error
MemoryCard
(No
indication
patterns
available)