Filter
Top Products
Using the Operation Panel
ADVANCED OPERATION GUIDE 2-81
4
Press U or V repeatedly until >Duplex
Mode appears.
5
Press [OK]. A blinking question mark (?)
appears.
6
Press U or V to display the desired duplex mode. The display changes as
shown below.
Off (default)
Short edge bind
Long edge bind
7
When the desired duplex mode is displayed, press [OK].
8
Press [MENU]. The message display returns to Ready.
Selecting the Output Stack
You can select whether printouts will be received by the printer’s top tray
(face-down) or to the optional document finisher’s output tray.
1
Press [MENU].
2
Press U or V repeatedly until Paper
Handling > appears.
3
Press Z.
4
Press U or V repeatedly until >Stack
Select appears.
5
Press [OK]. A blinking question mark (?)
appears. The selected output device will be
displayed.
6
Press U or V to display the desired destination. The output tray changes
depending on an installed option.
7
When the desired paper source is displayed, press [OK].
8
Press [MENU]. The message display returns to Ready.
>Duplex Mode
Off
>Duplex Mode
? Off
Paper Handling >
>Stack Select
Top tray FaceDn
>Stack Select
? Top tray FaceDn