Using the Operation Panel
ADVANCED OPERATION GUIDE 2-95
Finishing
These settings are possible only when the optional finisher is installed on
the printer.
Duplex Printing Error Detection Setting
This setting controls whether or not the message Duplex disabled
Press GO appears when label or some other type of paper that is not
supported for duplex printing is specified as the paper type when duplex
printing is being performed.
1
Press [MENU].
2
Press U or V repeatedly until Others >
appears.
3
Press Z.
4
Press U or V repeatedly until
>Finishing Error > appears.
5
Press Z.
6
Press U or V repeatedly until >>Duplex
appears.
7
Press [OK]. A blinking question mark (?)
appears.
8
Press U or V to change Off to On.
9
Press [OK].
10
To exit the menu selection, press [MENU].
On
•Press [GO] to perform simple printing.
•Press [CANCEL] to cancel the print job.
Off Disable duplex printing. (reverts to simplex printing)
Others >
>Finishing >
Error
>>Duplex
Off
>>Duplex
? Off