Filter
Top Products
Using the Operation Panel
2-4 ADVANCED OPERATION GUIDE
Message Display
The message display gives information in the form of short messages. The
nine messages listed below are displayed during normal warm-up and
printing.
Other messages that may appear when the printer needs the operator’s
attention are explained on page 4-7 in the Operation Guide.
Message Meaning
Self test The printer is self-testing after power-up.
Original toner
installed
The installed toner container is displayed if
determined to be original toner container by
the self-diagnostic performed after power is
switched on.
When using an original Kyocera toner
container, toner remaining warnings and toner
replacement messages are at times displayed
in the operation panel.
Please wait The printer is warming up and is not ready.
When the printer is switched on for the first
time after the toner container is installed,
(Adding toner) also appears.
Ready The printer is ready to print.
Processing The printer is receiving data, generating
graphics, reading a memory card/hard disk, or
printing.
Sleeping The printer is in Sleep mode. The printer
wakes from Sleep mode whenever a key on
the operation panel is pressed, the cover is
opened or closed, or data is received. The
printer then warms up and goes online. The
time that the printer takes to enter Sleep mode
depends on the Sleep Timer setting.
Canceling data Jobs inside the printer are being canceled. To
cancel a job, refer to the table on page 2-8.
Waiting The printer is waiting for the end-of-job
command before printing the last page.
Pressing [GO] allows you to obtain the last
page immediately.
FormFeed
TimeOut
The printer is printing the last page after a
waiting period.