Filter
Top Products
2-16 Preparation for Usage
5 Original eject table
6 Original stopper
7 Opening handle
Originals Supported by the Document Processor
The document processor supports the following types of originals.
Originals Not Supported by the Document Processor
Do not use the document processor for the following types of originals.
• Soft originals such as vinyl sheets
• Transparencies such as OHP film
• Carbon paper
• Originals with very slippery surfaces
• Originals with adhesive tape or glue
• Wet originals
• Originals with correction fluid which is not dried
• Irregularly shaped (non-rectangular) originals
• Originals with cut-out sections
• Crumpled paper
• Originals with folds (Straighten the folds before loading. Failure to do
so may cause the originals to jam).
• Originals bound with clips or staples (Remove the clips or staples
and straighten curls, wrinkles or creases before loading. Failure to
do so may cause the originals to jam).
How to Load Originals
1 Adjust the original width guides to the width of the originals.
Item Specifications
Weight 45 g/m² to 160 g/m²
Size Maximum 11 × 17" to Minimum 5 1/2 × 8 1/2"
Maximum A3 to Minimum A5R
Capacity Plain paper (80 g/m²), Colored paper, Recycled
paper: 75 sheets (Mixed sized originals: 30 sheets)
Thick paper (120 g/m²): 49 sheets
Thick paper (160 g/m²): 37 sheets
Art paper: 1 sheet
High quality paper (110 g/m²): 54 sheets
IMPORTANT Before loading originals, be sure there are no originals
left on the original eject table. Left originals may cause the new
originals to jam.