Filter
Top Products
Netware 3.x - Advanced Settings
4 - 6 NetWare Configuration
Netware 3.x - Advanced Settings
Preparation
The following procedures use the Property Sheet method in configuring the Network Interface
Card. If you configure the Network Interface Card as a NetWare print server for the first time after
physically installing it, we recommend you use the Wizard method.
Note: This section assumes NetWare is functional and that the necessary
environment for the NetWare Print Service is available.
Setting Up as Print Server
1
Log in to the file server as a Supervisor or a Supervisor equivalent.
2
Run the NIC Setup Tool.
3
Click [Property Sheet] and click [OK].
•
The Browse dialog of the Network Interface Card appears.
4
Click [IPX protocol].
5
Select the IPX address of the Network Interface Card which is to be configured by clicking
it, and click [Next].
Note: If you don't know which Network Interface Card you are configuring, print
the Configuration Page using the printer's operation panel, and select the MAC
address that is on the page.
The actual procedures for configuring your printer differ depending on whether the Network
Interface Card is configured as a print server or as a remote printer. This section describes how
to configure it in the NetWare 3.x environment.
Basic Procedure
Installing the NIB Setup Tool
Print Server Remote Printer
Configuring the Network Interface Card
Configuring the NetWare
Turning the power
off and on
Start the Print Server