Filter
Top Products
Remote Maintenance by Telnet (mshell)
Additional Functions 6 - 13
SNMP
Use the snmp command to display and edit SNMP configuration settings such as the community
name.
Note:
•
You can configure from No. 1 to 10 SNMP settings.
•
The factory default settings for No. 1 and 2 are as follows.
5
Display
Shows the SNMP information and available protocols.
msh> snmp ?
msh> snmp [-p] [registered_number]
Notes:
•
If the -p option is added, you can view the displays one by one.
•
If the registered number is not added, you can view the status of all the registered
numbers.
Community Name Configuration
You can set the community name of the Network Interface Card.
msh> snmp number name community_name
Note
•
The community name must consist of 15 characters or less.
Number 1 2
community name public admin
IP address 0.0.0.0 0.0.0.0
access type read-only
trap off
read-write
trap off