Filter
Top Products
Remote Maintenance by Telnet (mshell)
Additional Functions 6 - 15
The following is an example of how to configure registration number 3 with the IP address
192.168.15.16.
msh> snmp 3 ip 192.168.15.16
The following is an example of how to configure registration number 3 with the IPX address
7390A448, and the MAC address 00:00:74:62:5C:65.
msh> snmp 3 ipx 7390A448.000074625C65
Changing the Password
Use the passwd command to change the remote maintenance password.
•
Be sure not to forget or lose the password.
•
The default factory password is “password”.
1
Enter “passwd”.
•
msh> passwd
2
Enter the current password.
•
Old password:
3
Enter the new password.
•
New password:
Note: The password must consist of 3 to 8 alphanumeric characters and symbols.
Upper and lower case characters are considered unique. For example, R is
different from r.
The password is the same as that used in the configuration of the Network
Interface Card using a Web browser and that used in the NIC Setup Tool. If you
change a password on the mshell, the other passwords are also changed.
4
Enter the new password once again.
•
Retype new password.