Lantronix Hub Switch User Manual


 
MSS User Guide 2: Installation
2-4
The following diagram shows a properly installed MSS-VIA. The numbers in the diagram
refer to the installation steps in this section.
Figure 2-5: MSS-VIA Connected to Serial Device and Network
1. Connect the MSS to a serial device.
a) Connect one end of a serial cable to the MSS DB25 or DB9 connector. See
Chapter 7:Pinouts for MSS connector pinout information.
You may want to connect a serial terminal to the MSS DB9 console port for the
first connection, both to ensure that your device server is working and to
configure the necessary network settings. The default settings for the console
port are 9600 baud, 8 data bits, one stop bit, no parity, and no flow control.
b) Connect the other end of the cable to your serial device's serial port.
2. Connect the MSS to the network via one of the following methods:
a) Connect one end of a Category 5 Ethernet cable to the Ethernet network.
Connect the other end of the cable to the RJ45 Ethernet port on the back of the
MSS.
Note: You must use a 10/100BASE-T wired connection if you wish to perform
initial configuration via the network.
b) Insert an 802.11 wireless PC card into the MSS PC card slot. To see which
wireless PC cards the MSS supports, visit the Lantronix Web site at
http://www.lantronix.com
.
Note: Any time you insert a PC card into the MSS PC card slot, you must reboot
the MSS so it can identify and initialize the card. Reboot the MSS by removing
and replacing the power cord. Do not remove the PC card while the MSS is
powered on.
3. Supply power to the MSS.
a) Connect the barrel jack end of the power cable to the MSS power jack.
b) Connect the power cube end of the power cable to a standard wall outlet.
c) When the MSS receives power, it will begin a three-step boot process.