Filter
Top Products
Command Reference Change DSRLogout
2-22
2.16 Change DSRLogout
If DSRLogout is enabled, the specified port will be logged out when its DSR signal is de-asserted. This
logout usually happens only when the attached device is turned off or disconnected. The feature can be used
to keep users from switching physical terminal lines to access other sessions. Open connections will be
closed before logout.
Restrictions Requires privileged user status.
Does not apply to the MSS485.
Errors Modem Control must be disabled to use DSRLogout. Modem Control implies
DSRLogout.
Parameters
Port
MSS4 only. Specifies a particular port or group of ports.
Note: In the absence of the PortList parameter, the configuration will affect the MSS4’s
current port only.
PortList
Specify a particular port or group of ports. Port numbers are specified with
integers between 1 and 4, and should be separated with commas (for lists) or
dashes (for ranges).
Defaults Disabled
See Also Change Modem Control, page 2-31.
2.17 Change DTRWait
If enabled, the MSS will not assert the DTR signal on the specified serial port until a user logs into the port,
or until a network connection is made to the port.
Restrictions Requires privileged user status.
Does not apply to the MSS485.
Parameters
Port
MSS4 only. Specifies a particular port or group of ports.
Note: In the absence of the PortList parameter, the configuration will affect the MSS4’s
current port only.
CHANGE
PORT PortList
DSRLOGOUT
DISABLED
ENABLED
CHANGE
PORT PortList
DTRWAIT
DISABLED
ENABLED