Filter
Top Products
Command Reference Change Software
2-45
Examples
CHANGE SNMPSETCOMM WPHRED
(adds a single community with read-write access)
See Also The Configuration chapter of your Installation Guide
2.57 Change Software
Specifies the name of the download file that, when a reload has been requested, the MSS will attempt to
load at boot time.
Restrictions Requires privileged user status.
Parameters
Server
MSS4 only.
filename
Specify a loadfile name of 11 or fewer characters. The server will
automatically add a .SYS extension to the file name. You can also enter the
complete pathname if the file is to be loaded via TFTP; place the filename in
quotes to preserve case.
See Also Change Loadhost, page 2-29.
2.58 Change Speed
Specifies the baud rate of the serial port.
Restrictions Requires privileged user status.
Errors An error is displayed if an unsupported baud rate is specified.
Parameters
Port
MSS4 only. Specifies a particular port or group of ports.
Note: In the absence of the PortList parameter, the configuration will affect the MSS4’s
current port only.
PortList
Specify a particular port or group of ports. Port numbers are specified with
integers between 1 and 4, and should be separated with commas (for lists) or
dashes (for ranges).
CHANGE
SERVER
SOFTWARE filename
CHANGE
PORT PortList
SPEED rate