Filter
Top Products
Command Reference Change Flow Control
2-23
PortList
Specify a particular port or group of ports. Port numbers are specified with
integers between 1 and 4, and should be separated with commas (for lists) or
dashes (for ranges).
Defaults Disabled
2.18 Change Flow Control
Sets the type of flow control to be used on the specified port.
Restrictions Requires privileged user status.
Does not apply to the MSS485.
Errors CTSRTS Flow Control is not available in RS-485 mode.
Parameters
Port
MSS4 only. Specifies a particular port or group of ports.
Note: In the absence of the PortList parameter, the configuration will affect the MSS4’s
current port only.
PortList
Specify a particular port or group of ports. Port numbers are specified with
integers between 1 and 4, and should be separated with commas (for lists) or
dashes (for ranges).
CTSRTS
Uses RTS/CTS, or hardware, flow control.
None
Flow control is not used.
XONXOFF
Uses XONXOFF, or software, flow control.
Defaults XONXOFF
CHANGE
PORT PortList
FLOW CONTROL
CTSRTS
NONE
XONXOFF