Filter
Top Products
7. Reinstall the screw to secure the frame stand to the computer. Recover the screw hole with the
sheetmetal.
Figure 7. Reinstalling the screw to secure the frame stand to the computer
Removing and installing the monitor stand
Attention: Do not open your computer or attempt any repair before reading and understanding the
“Important safety information” on page 1
This section provides instructions on how to install the monitor stand.
Note: The monitor stand is available only in some models.
To install the monitor stand, do the following:
1. Remove any media from the drives and turn off all attached devices and the computer.
2. Disconnect all power cords from electrical outlets.
3. Disconnect the power cords, Input/Output cables, and any other cables that are connected to the
computer. See “Locating connectors, controls, and indicators on the front of your computer” on page
65 and “Locating connectors on the rear of your computer” on page 66.
4. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
5. If your computer is installed with a frame stand, remove the frame stand. See “Removing and reinstalling
the frame stand” on page 71
Chapter 9. Replacing FRUs 73